Cities of Sigmar – Elthwin’s Thorns
•REGIMENT OF RENOWN•
Elthwin’s Thorns
The soulpod grove in which Elthwin’s lamentiri was incubated was ransacked by ghouls and touched by maddening energies. Over time, the spirit-song that naturally envelops her fellow Sylvaneth has become torturously faint to Elthwin, and it is only the Arch-Revenant’s strength of will that has staved off insanity. | ||
•REGIMENT OF RENOWN•
Elthwin’s Thorns
INCLUSION This Regiment of Renown can be included in armies from the following factions: | ||
 Your Shooting Phase |
GOSSAMID CHAMPION: Elthwin directs her Gossamid kin to let fly volleys of suppressing shots.
Declare: Pick the Arch-Revenant in this Regiment of Renown to use this ability, the pick a visible enemy unit within 12" of them to be the target.
Effect: Until the start of your next turn, subtract X from charge rolls for the target, where X is the number of damage points allocated to the target this phase by shooting attacks made by the Gossamid Archers unit in the Regiment of Renown, to a maximum of 6.
Effect: Until the start of your next turn, subtract X from charge rolls for the target, where X is the number of damage points allocated to the target this phase by shooting attacks made by the Gossamid Archers unit in the Regiment of Renown, to a maximum of 6.
| Once Per Turn (Army), Your Shooting Phase |
FLIGHT OF THE ZEPHYRSPITES: In their effort to reach Alarielle’s court and be healed, Elthwin’s Thorns are carried by swift and loyal Zephyrspites.
Effect: If both units in this Regiment of Renown are within each other’s combat range and neither unit is in combat, roll a dice. On a 3+, remove both units from the battlefield, then set them up again within each other’s combat range, wholly within 3" of a terrain feature and more than 9" from all enemy units.
Universal Core Abilities - Charge Phase
 Your Charge Phase |
CHARGE: With a mighty battle cry, the warriors charge into combat with the enemy.
Declare: Pick a friendly unit that is not in combat and has not used a RUN or RETREAT ability this turn to use this ability. Then, make a charge roll of 2D6.
Effect: That unit can move a distance up to the value of the charge roll. That unit can move through the combat ranges of any enemy units and must end that move within 1/2" of a visible enemy unit. If it does so, the unit using this ability has charged.
Effect: That unit can move a distance up to the value of the charge roll. That unit can move through the combat ranges of any enemy units and must end that move within 1/2" of a visible enemy unit. If it does so, the unit using this ability has charged.
| KEYWORDS | CORE, MOVE, CHARGE |
Hit Roll
Roll a dice. If the roll equals or exceeds the attacking weapon’s Hit characteristic, the attack scores a successful hit: move on to the next step. If not, the attack fails and the attack sequence ends. Unmodified hit rolls of 1 always fail. If an unmodified hit roll for an attack made with a weapon is a 6, that attack is a critical hit.| Critical hits have no effect on their own but often trigger additional effects (see 20.0 Weapon Abilities). | ||
Cover
Subtract 1 from hit rolls for attacks that target a unit that is behind or wholly on this terrain feature, unless that unit charged this turn or has the FLY keyword.17.2 Mortal Damage
Some abilities inflict mortal damage. If an ability inflicts mortal damage on a unit, add that number of damage points to the unit’s damage pool for that ability (see 18.2 Allocating Damage).
| Your Movement Phase |
RETREAT: The fighters disengage from combat, though at the cost of lowering their defences.
Declare: Pick a friendly unit that is in combat to use this ability.
Effect: Inflict D3 mortal damage on that unit. That unit can move a distance up to its Move characteristic. That unit can move through the combat ranges of any enemy units but cannot end that move within an enemy unit’s combat range.
Effect: Inflict D3 mortal damage on that unit. That unit can move a distance up to its Move characteristic. That unit can move through the combat ranges of any enemy units but cannot end that move within an enemy unit’s combat range.
| KEYWORDS | CORE, MOVE, RETREAT |
7.0 Combat Range
Each model has a combat range that extends 3" horizontally from its base and any distance vertically from that circle to form a cylinder. The combat range of a unit extends 3" horizontally and any distance vertically from every model in that unit. Units from opposing armies that are within each other’s combat range and that are visible to each other are in combat with each other. When a unit that is not in combat enters the combat range of a visible enemy unit, it moves into combat.
A model is considered to be in combat with an enemy unit if that unit is within the model’s combat range and visible to it’
A model is considered to be in combat with an enemy unit if that unit is within the model’s combat range and visible to it’
| ||
FAQ / Errata
FAQ
| Q: | If a model in base-to-base contact with an enemy model retreats 3" directly away from the enemy model, is it still in combat with that enemy model? |
| A: | No. |
Errata
Addenda: 7.0 Combat Range
Add the following:
‘A model is considered to be in combat with an enemy unit if that unit is within the model’s combat range and visible to it.’
‘A model is considered to be in combat with an enemy unit if that unit is within the model’s combat range and visible to it.’
| Passive |
FLY: Soaring above the battlefield, this unit can reach destinations that are inaccessible to other troops.
Effect: As this unit moves, it ignores other models, terrain features and the combat ranges of enemy units. It cannot end its move in combat unless specified in the ability that allowed it to move. Ignore any vertical distance moved for this unit.
Obscuring
While every model in a non-MONSTER non‐WAR MACHINE unit that does not have the FLY keyword is within 1" of this terrain feature, the following apply:- That unit is only visible to enemy units that are within its combat range.
- The Range characteristic of that unit’s ranged weapons is halved (rounding down to the nearest inch).
Unstable
Models can move across but cannot be set up on or end any type of move on any part of this terrain feature that is more than 1" tall.1.4.2 Obscuring Terrain
Examples: Wyldwood, fortress wallTerrain Abilities: Cover, Obscuring, Unstable
6.0 Visibility
A target model is visible to another model (which we’ll call the ‘observing model’) if you can draw a straight line through the air (whether horizontal, diagonal or vertical) from any point on the observing model to any point on the target model that does not intersect any objects except for other models in the observing model’s unit. A target unit is visible to an observing unit if at least 1 model in the target unit is visible to at least 1 model in the observing unit. A model is always considered to be visible to itself.If a rule or ability requires a target to be both within a given range of and visible to the unit using that ability, or to a model in that unit, both conditions must be met by the same model in the target. You could not, for instance, target a unit where one model is within range but not visible and another model is not in range but is visible.
| ||
| In some cases, it might not be immediately clear whether a model is visible. If so, stoop down to get a look from behind the observing model. If any part of the other model is visible, even if it is just the tip of a spear, then that model is visible for rules purposes. | ||
FAQ / Errata
FAQ
| Q: | If a non-FLY INFANTRY HERO (e.g. a Scinari Cathallar) is a Shrine Guardian of a Shrine Luminor, and that Shrine Guardian is within 1" of an obscuring terrain feature, is the Shrine Guardian visible to enemy abilities that target the Shrine Guardian? |
| A: | Yes. |
Errata
6.0 Visibility
Add the following:
‘If a rule or ability requires a target to be both within a given range of and visible to the unit using that ability, or to a model in that unit, both conditions must be met by the same model in the target. You could not, for instance, target a unit where one model is within range but not visible and another model is not in range but is visible.’
‘If a rule or ability requires a target to be both within a given range of and visible to the unit using that ability, or to a model in that unit, both conditions must be met by the same model in the target. You could not, for instance, target a unit where one model is within range but not visible and another model is not in range but is visible.’
| Your Charge Phase |
CHARGE: With a mighty battle cry, the warriors charge into combat with the enemy.
Declare: Pick a friendly unit that is not in combat and has not used a RUN or RETREAT ability this turn to use this ability. Then, make a charge roll of 2D6.
Effect: That unit can move a distance up to the value of the charge roll. That unit can move through the combat ranges of any enemy units and must end that move within 1/2" of a visible enemy unit. If it does so, the unit using this ability has charged.
Effect: That unit can move a distance up to the value of the charge roll. That unit can move through the combat ranges of any enemy units and must end that move within 1/2" of a visible enemy unit. If it does so, the unit using this ability has charged.
| KEYWORDS | CORE, MOVE, CHARGE |
14.3 Charge Phase
| Your Charge Phase |
CHARGE: With a mighty battle cry, the warriors charge into combat with the enemy.
Declare: Pick a friendly unit that is not in combat and has not used a RUN or RETREAT ability this turn to use this ability. Then, make a charge roll of 2D6.
Effect: That unit can move a distance up to the value of the charge roll. That unit can move through the combat ranges of any enemy units and must end that move within 1/2" of a visible enemy unit. If it does so, the unit using this ability has charged.
Effect: That unit can move a distance up to the value of the charge roll. That unit can move through the combat ranges of any enemy units and must end that move within 1/2" of a visible enemy unit. If it does so, the unit using this ability has charged.
| KEYWORDS | CORE, MOVE, CHARGE |
FAQ
| Q: | When using the ‘Charge’ ability, does my unit need to end the charge move within 1⁄2" of an enemy unit that was visible to the charging unit at the start of that charge move? |
| A: | No. It must end the charge move within 1⁄2" of an enemy unit that is visible to the charging unit when it finishes that charge move. |
| Q: | If an ability adds to or subtracts from the number of dice that make up a charge roll, is that a modifier to the charge roll? |
| A: | No. |
Shooting attacks
Shooting attacks are made with ranged weapons. The target unit(s) must be within a distance equal to the Range characteristic of the weapon being used and visible to the attacking model. Models cannot make shooting attacks if their unit is in combat, unless otherwise specified (see 20.0 Weapon Abilities).18.2 Allocating Damage
After resolving the effect of any ability that inflicts damage points (whether via attacks, mortal damage or both), you must allocate the damage points.When allocating damage points to a unit, the damage points in its damage pool are allocated to it one at a time. Each time the number of damage points allocated to the unit equals the Health characteristic of that unit, 1 model in that unit is slain (and removed from play) and the number of damage points allocated to that unit is reset to 0. Keep allocating damage points until there are none left in the damage pool.
If the number of damage points allocated to a unit is not enough to slay a model, keep track of the number of damage points currently allocated to the unit (most players place a dice or markers next to the unit). While a unit has any damage points allocated to it, it is damaged.
3.5 Regiments of Renown
In addition to creating your own regiments, you can also spend points to include 1 Regiment of Renown. Regiments of Renown are pre-built regiments, each with their own special abilities. The rules for each Regiment of Renown will specify which factions can include it. A unit in a Regiment of Renown cannot be your general even if it is a WARMASTER.- You cannot include more than one Regiment of Renown in your army unless otherwise specified in the notes column of that regiment’s battle profile.
- Units in a Regiment of Renown cannot use (but can be picked as the target of, if otherwise eligible) any faction rules from the faction they are allied into, including enhancements and lores.
- If an ability allows you to set up a replacement unit (Core Rules, 24.2) for a unit in a Regiment of Renown, that unit also counts as being part of that Regiment of Renown.