Renegades and Heretics – Scout Sentinels
This datasheet does not meet the selection criteria (see Settings tab).
3

Scout Sentinels

NoNAME  M WS BS S T W A Ld Sv Base
35
Scout Sentinel (base: 60mm)
1‑3
35
Scout Sentinel
9" 4+ 4+ 5 5 6 1 7 4+ 60mm
This unit contains 1 Scout Sentinel. It can include 1 additional Scout Sentinel (Power Rating +3) or 2 additional Scout Sentinels (Power Rating +6). Each model is equipped with a multi-laser.
WEAPON
RANGE
TYPE
S
AP
D
ABILITIES 
+10
Autocannon
+10
Autocannon
48"
Heavy 2
7
-1
2
-
+10
Heavy flamer
+10
Heavy flamer
12"
Heavy D6
5
-1
1
Each time an attack is made with this weapon, that attack automatically hits the target.
Each time an attack is made with this weapon, that attack automatically hits the target.
+5
Hunter-killer missile
+5
Hunter-killer missile
48"
Heavy 1
10
-2
D6
The bearer can only shoot with each hunter-killer missile it is equipped with once per battle.
The bearer can only shoot with each hunter-killer missile it is equipped with once per battle.
+15
Lascannon
+15
Lascannon
48"
Heavy 1
9
-3
D6
-
+15
Missile launcher
When attacking with this weapon, choose one of the profiles below.
+15
Missile launcher
When attacking with this weapon, choose one of the profiles below.
 - Frag missile
 - Frag missile
48"
Heavy D6
4
0
1
Blast
Blast
 - Krak missile
 - Krak missile
48"
Heavy 1
8
-2
D6
-
Multi-laser
Multi-laser
36"
Heavy 3
6
0
1
-
+2
Sentinel chainsaw
+2
Sentinel chainsaw
Melee
Melee
User
-1
1
-
WARGEAR OPTIONS
WARGEAR OPTIONS
 • Any model may replace its multi-laser with a heavy flamer, autocannon, missile launcher or lascannon.
 • Any model may take a Sentinel chainsaw.
 • Any model may take a hunter-killer missile.
ABILITIES
ABILITIES
Explodes: If a model in this unit is reduced to 0 wounds, roll a D6 before removing the model from the battlefield. On a 6 it explodes, and each unit within 3" suffers 1 mortal wound.
Scout Vehicle: At the start of the first battle round but before the first turn begins, you can move this unit up to 9". It cannot end this move within 9" of any enemy models.
Smoke Launchers: Once per game, instead of shooting any weapons in the Shooting phase, this unit can use its smoke launchers; until your next Shooting phase your opponent must subtract 1 from all hit rolls for ranged weapons that target it.
FACTION KEYWORDS: CHAOS, RENEGADES AND HERETICS
KEYWORDS: VEHICLE, SCOUT SENTINELS

Autocannon used in the following datasheets:


– may take Autocannon as an option.
HEAVY
Heavy weapons are amongst the biggest guns on the battlefield, but they require bracing to fire at full effect and are unwieldy to bring to bear at close quarters.
When an INFANTRY model shoots a Heavy weapon, subtract 1 from the hit rolls when resolving that weapon’s attacks if the firing model’s unit has moved for any reason this turn (e.g. it made a Normal Move this turn).

  • Subtract 1 from hit rolls if firing model is INFANTRY and its unit has moved this turn.

Hunter-killer missile used in the following datasheets:


– may take Hunter-killer missile as an option.

Lascannon used in the following datasheets:

Flyers

– may take Lascannon as an option.
Hit Roll
When a model makes an attack, make one hit roll for that attack by rolling one D6. If the result of the hit roll is equal to or greater than the attacking model’s Ballistic Skill (BS) characteristic (if the attack is being made with a ranged weapon) or its Weapon Skill (WS) characteristic (if the attack is being made with a melee weapon), then that attack scores one hit against the target unit. If not, the attack fails and the attack sequence ends.

If an attack is made with a weapon that has an ability that says it ‘automatically hits the target’, no hit roll is made – that attack simply scores one hit on the target unit. An unmodified hit roll of 6 always scores a hit, and an unmodified hit roll of 1 always fails. A hit roll can never be modified by more than -1 or +1. This means that if, after all the cumulative modifiers to a hit roll have been calculated, the total modifier would be -2 or worse, it is changed to be -1. Similarly, if, after all the cumulative modifiers to a hit roll have been calculated, the total modifier would be +2 or better, it is changed to be +1.
Mortal Wounds
Some attacks inflict mortal wounds – these are so powerful that no armour or force field can withstand their fury. Each mortal wound inflicts 1 point of damage on the target unit, and they are always applied one at a time. Do not make a wound roll or saving throw (including invulnerable saves) against a mortal wound – just allocate it as you would any other attack and inflict damage to a model in the target unit. Unlike damage inflicted by normal attacks, excess damage from mortal wounds is not lost. Instead, keep allocating damage to another model in the target unit until either all the damage has been allocated or the target unit is destroyed.

If an attack inflicts mortal wounds in addition to the normal damage, resolve the normal damage first. If an attack inflicts mortal wounds in addition to the normal damage, but the normal damage is subsequently saved, the target unit still suffers the mortal wounds, as described before. If an ability modifies the damage inflicted by a weapon, and that weapon can inflict mortal wounds in addition to the normal damage, the modifier does not apply to any mortal wounds that are inflicted (unless the rule specifically states otherwise).

  • Each mortal wound inflicted on a unit causes one model in the unit to lose one wound.
  • No saving throws can be made against mortal wounds.
  • Mortal wounds inflicted by attacks in addition to normal damage always apply, even if normal damage saved.
Faction Rules

This datasheet has Fast Attack Battlefield Role. Full list of Renegades and Heretics units sharing same Battlefield Role follows:

Blast Weapons
Some weapons have ‘Blast’ listed in their profile’s abilities. These are referred to as Blast weapons. In addition to the normal rules, the following rules apply to Blast weapons:
  1. If a Blast weapon targets a unit that has between 6 and 10 models, it always makes a minimum of 3 attacks. So if, when determining how many attacks are made with that weapon, the dice rolled results in less than 3 attacks being made, make 3 attacks instead. For example, if a Grenade D6 weapon with the Blast rule targets a unit that has 6 or more models, and you roll a 2 to determine how many attacks are made, that roll is counted as being a 3 and that weapon makes three attacks against that unit.
  2. When a Blast weapon targets a unit that has 11 or more models, do not roll dice to randomly determine how many attacks are made – instead, make the maximum possible number of attacks. For example, if a Grenade D6 weapon with the Blast rule targets a unit that has 11 or more models, that weapon makes six attacks against that unit.
Blast weapons can never be used to make attacks against a unit that is within Engagement Range of the firing model’s unit, even if the weapon has the Pistol type or if the firing model is a VEHICLE or a MONSTER – firing high-explosives at point-blank range is simply unwise.

  • Blast Weapons: Minimum three attacks against units with 6+ models. Always make maximum number of attacks against units with 11+ models.
  • Can never be used to attack units within the firing unit’s Engagement Range.

Missile launcher used in the following datasheets:


– may take Missile launcher as an option.

Multi-laser used in the following datasheets:

Dedicated Transport
Flyers

Sentinel chainsaw used in the following datasheets:

Select Weapon
When a model makes a close combat attack, it must do so using a melee weapon (i.e. a weapon that has the ‘Melee’ type). The weapons a model is equipped with are described on its datasheet. If a model is not equipped with any melee weapons, or if it cannot make an attack with any of the melee weapons it is equipped with, then that model makes its attacks using a close combat weapon, which has the following profile:

WEAPONRANGETYPESAPD
Close combat weaponMeleeMeleeUser01

If a model has more than one melee weapon, select which it will use before resolving any attacks. If a model has more than one melee weapon and can make several attacks, it can split them between these weapons however you wish – declare which attacks are being made with which weapons before any attacks are resolved. If the selected weapon has more than one profile that you must choose between, you must declare which profile is being used at the same time. Different attacks made with such a weapon can be made using different profiles if you wish.

If your unit is making attacks with more than one melee weapon against a unit, and those weapons have different characteristics profiles, then after you have resolved an attack with one of those weapons you must, if any other weapons with the same characteristics profile are also being used to make attacks against that unit, resolve those attacks before resolving any attacks against the target with a weapon that has a different characteristics profile. Note that all the attacks you have declared are always resolved against the target unit even if, when you come to resolve an individual attack, no models in the target unit remain in range (this can happen because of models being destroyed and removed from the battlefield as the result of resolving other attacks made by the attacking model’s unit first).

  • Each close combat attack is made with a melee weapon.
  • A model makes attacks using the close combat weapon profile if it has no other melee weapons.
  • If a unit attacks with multiple weapons, all attacks made with weapons that have the same profile must be resolved before resolving attacks with the next.
© Vyacheslav Maltsev 2013-2021