Renegades and Heretics – Malefic Lord
This datasheet does not meet the selection criteria (see Settings tab).
3

Malefic Lord

NoNAME  M WS BS S T W A Ld Sv Base
50
Malefic Lord (base: 25mm)
1
50
Malefic Lord
6" 4+ 4+ 3 3 4 3 8 7+ 25mm
A Malefic Lord is equipped with: bare hands.
WEAPON
RANGE
TYPE
S
AP
D
ABILITIES 
Bare hands
Bare hands
Melee
Melee
User
0
1
-
ABILITIES
ABILITIES
Master Witch: This model has a 4+ invulnerable save.
Covenant of Chaos: Each time this unit fights, if it made a charge move, was charged, or performed a Heroic Intervention this turn, then until that fight is resolved, add 1 to the Strength characteristic of models in this unit.
Warp Possession: If this model suffers Perils of the Warp and is not destroyed:
  • Its Weapon Skill characteristic is changed to 2+.
  • Its Strength characteristic is changed to 8.
  • Its Attacks characteristic is changed to 5.
  • The Armour Penetration characteristic of bare hands it is equipped with is changed to -2.
  • The Damage characteristic of bare hands it is equipped with is changed to 2.
PSYKER
PSYKER
This model can attempt to manifest one psychic power in your Psychic phase and attempt to deny one psychic power in your opponent’s Psychic phase. It knows Smite.
FACTION KEYWORDS: CHAOS, RENEGADES AND HERETICS
KEYWORDS: INFANTRY, CHARACTER, PSYKER, MALEFIC LORD
Engagement Range
Engagement Range represents the zone of threat that models present to their enemies. While a model is within 1" horizontally and 5" vertically of an enemy model, those models are within Engagement Range of each other. While two enemy models are within Engagement Range of each other, those models’ units are also within Engagement Range of each other. Models cannot be set up within Engagement Range of enemy models.

  • Engagement Range: 1" horizontally + 5" vertically.
  • Models cannot be set up within Engagement Range of enemy models.
Charging with a Unit
Once you have chosen an eligible unit to declare a charge with, you must select one or more enemy units within 12" of it as the targets of its charge. The target(s) of this charge do not need to be visible to the charging unit. You then make a charge roll for your unit by rolling 2D6. This is the maximum number of inches each model in the charging unit can now be moved if they can make the charge move. To make a charge move, the unit’s charge roll must be sufficient that it is able to end that move in unit coherency and within Engagement Range of every unit that was a target of its charge, without moving within Engagement Range of any enemy units that were not a target of its charge. If this is possible, then the charge is successful and the models in the unit make a charge move so as to fulfil the above conditions. If this is impossible, the charge fails and no models in the charging unit move this phase.

  • Declare targets of the charge (must be within 12").
  • Charge roll = 2D6".
  • If insufficient to move charging unit into Engagement Range of all targets, charge fails.
  • If charge successful, models make their charge move.
  • Cannot make a charge move within Engagement Range of any unit that was not the target of the charge.
Faction Rules
Select Weapon
When a model makes a close combat attack, it must do so using a melee weapon (i.e. a weapon that has the ‘Melee’ type). The weapons a model is equipped with are described on its datasheet. If a model is not equipped with any melee weapons, or if it cannot make an attack with any of the melee weapons it is equipped with, then that model makes its attacks using a close combat weapon, which has the following profile:

WEAPONRANGETYPESAPD
Close combat weaponMeleeMeleeUser01

If a model has more than one melee weapon, select which it will use before resolving any attacks. If a model has more than one melee weapon and can make several attacks, it can split them between these weapons however you wish – declare which attacks are being made with which weapons before any attacks are resolved. If the selected weapon has more than one profile that you must choose between, you must declare which profile is being used at the same time. Different attacks made with such a weapon can be made using different profiles if you wish.

If your unit is making attacks with more than one melee weapon against a unit, and those weapons have different characteristics profiles, then after you have resolved an attack with one of those weapons you must, if any other weapons with the same characteristics profile are also being used to make attacks against that unit, resolve those attacks before resolving any attacks against the target with a weapon that has a different characteristics profile. Note that all the attacks you have declared are always resolved against the target unit even if, when you come to resolve an individual attack, no models in the target unit remain in range (this can happen because of models being destroyed and removed from the battlefield as the result of resolving other attacks made by the attacking model’s unit first).

  • Each close combat attack is made with a melee weapon.
  • A model makes attacks using the close combat weapon profile if it has no other melee weapons.
  • If a unit attacks with multiple weapons, all attacks made with weapons that have the same profile must be resolved before resolving attacks with the next.
Saving Throw
The player commanding the target unit then makes one saving throw by rolling one D6 and modifying the roll by the Armour Penetration (AP) characteristic of the weapon that the attack was made with. For example, if the weapon has an AP of -1, then 1 is subtracted from the saving throw roll. If the result is equal to, or greater than, the Save (Sv) characteristic of the model the attack was allocated to, then the saving throw is successful and the attack sequence ends. If the result is less than the model’s Save characteristic, then the saving throw fails and the model suffers damage. An unmodified roll of 1 always fails.
Performing a Heroic Intervention
When a unit performs a Heroic Intervention, you can move each model in that unit up to 3" – this is a Heroic Intervention move. Each model in the unit must finish its Heroic Intervention move closer to the closest enemy model. Remember that a unit must finish any type of move in unit coherency.

  • Heroic Intervention: Move up to 3".
  • Must end closer to the closest enemy model.

This datasheet has HQ Battlefield Role. Full list of Renegades and Heretics units sharing same Battlefield Role follows:

Invulnerable Saves
Some models have an invulnerable save. Each time an attack is allocated to a model with an invulnerable save, you can choose to use either its normal Save (Sv) characteristic or its invulnerable save, but not both. If a model has more than one invulnerable save, it can only use one of them – choose which it will use. If you use a model’s invulnerable save, it is never modified by a weapon’s Armour Penetration value.

  • Invulnerable save: Saving throw that is never modified by attacking weapon’s AP.
  • A model with an invulnerable save can use it instead of its normal Sv.

The CHARACTER keyword is used in the following Renegades and Heretics datasheets:

Perils of the Warp
When a PSYKER unit suffers Perils of the Warp, it suffers D3 mortal wounds. If a PSYKER unit is destroyed by Perils of the Warp while attempting to manifest a psychic power, that power automatically fails to manifest. If a PSYKER unit is destroyed by Perils of the Warp, then just before removing the last model in that unit, every unit within 6" of it immediately suffers D3 mortal wounds.

  • Perils of the Warp: The PSYKER unit manifesting the power suffers D3 mortal wounds.
  • If PSYKER unit is destroyed, the psychic power fails to manifest.
  • If PSYKER unit destroyed, every other unit within 6" suffers D3 mortal wounds.
Manifesting Psychic Powers
The same PSYKER unit cannot attempt to manifest Smite more than once during the same battle round. When you select a PSYKER unit to manifest psychic powers, you select one psychic power that unit knows and attempt to manifest it. With the exception of Smite, you cannot attempt to manifest the same psychic power more than once in the same battle round, even with different PSYKER units.

To manifest the psychic power, you must first pass a Psychic test. The opposing player can then select one of their PSYKER units that is within 24" of the PSYKER unit attempting to manifest the power and attempt to deny that power before its effects are resolved by passing a Deny the Witch test.

So long as the Psychic test was successful and the psychic power was not denied by a successful Deny the Witch test, the psychic power is successfully manifested and its effects, which will be described in the power itself, are then resolved. If the PSYKER unit can attempt to manifest more than one psychic power in its Psychic phase, you can then attempt to manifest those, one at a time, as described above. The number of psychic powers each PSYKER unit can attempt to manifest in its Psychic phase is listed on its datasheet.

  • Select psychic power.
  • You cannot select the same psychic power more than once per battle round, unless that power is Smite.
  • Attempt to manifest the psychic power by taking a Psychic test.
  • The opponent can attempt to deny the psychic power by taking a Deny the Witch test.
  • If successfully manifested, resolve the psychic power’s effects.
  • Select another psychic power.
Deny the Witch
When a PSYKER unit attempts to deny a psychic power, you must take a Deny the Witch test for that unit by rolling 2D6. If the total is greater than the result of the Psychic test, the Deny the Witch test is passed and the psychic power is denied. Only one attempt can be made to deny a psychic power. If a PSYKER unit can attempt to deny more than one psychic power in a psychic phase, this will be listed on its datasheet.

  • Deny the Witch: Passed if 2D6 exceeds result of the opposing PSYKER’s Psychic test.
  • Only one attempt can be made to deny each psychic power.
Smite
Smite has a warp charge value of 5. Add 1 to the warp charge value of this psychic power for each other attempt that has been made to manifest this power by a unit from your army in this phase, whether that attempt was successful or not. If manifested, the closest enemy unit within 18" of and visible to the psyker suffers D3 mortal wounds. If the result of the Psychic test was 11 or more, that unit suffers D6 mortal wounds instead.

  • Warp Charge 5: A Psychic test of 5+ is required to manifest Smite.
  • Warp charge increases by 1 for each other attempt to manifest Smite made in this phase.
  • If manifested, closest visible enemy unit in 18" suffers D3 mortal wounds.
  • If manifested with a Psychic test result of 11+, enemy instead suffers D6 mortal wounds.

The PSYKER keyword is used in the following Renegades and Heretics datasheets:

© Vyacheslav Maltsev 2013-2021