Craftworlds – Vampire Hunter
This datasheet does not meet the selection criteria (see Settings tab).
30

Vampire Hunter

NoNAME  M WS BS S T W! A Ld Sv
600
Vampire Hunter
1
600
Vampire Hunter
20-50" 6+ 3+ 8 8 17-32 6 9 3+
20-40" 6+ 4+ 8 8 9-16 D6 9 3+
20-25" 6+ 5+ 8 8 1-8 D3 9 3+
A Vampire Hunter is equipped with: scatter laser; 2 twin pulse lasers; twin Vampire pulsar; spirit stones; crystal targeting matrix.
WEAPON
RANGE
TYPE
S
AP
D
ABILITIES 
Scatter laser
Scatter laser
36"
Heavy 4
6
0
1
-
Twin pulse laser
Twin pulse laser
48"
Heavy 4
8
-3
3
-
Twin vampire pulsar
Twin vampire pulsar
60"
Heavy 9
12
-4
D3+3
-
ABILITIES
ABILITIES
Airborne: This model cannot charge, can only be charged by units that can FLY, and can only attack or be attacked in the Fight phase by units that can FLY.
Hard to Hit: Subtract 1 from hit rolls for attacks that target this model in the Shooting phase.
Wings of Khaine: When this model Advances, add 20" to its Move characteristic for that Movement phase instead of rolling a dice. Each time this model moves, first pivot it on the spot up to 90° (this does not contribute to how far the model moves), and then move the model straight forwards. Once its move has finished, you can pivot it a further 90° as before.
Hover Jet: In your Command phase, this model can hover. If it does, then until the start of your next Command phase, its Move characteristic becomes 20" and it loses the Airborne, Hard to Hit and Wings of Khaine abilities.
Explodes: When this model is destroyed, roll one D6 before removing it from play. On a 6 it explodes, and each unit within 2D6" suffers D6 mortal wounds.
Crystal targeting matrix: If the bearer Advances, until the end of the turn, the type of any Heavy weapons it is equipped with are changed to Assault (e.g. a Heavy D6 weapon becomes an Assault D6 weapon).
Spirit stones: Roll a D6 each time a model with spirit stones suffers an unsaved wound or mortal wound: on a 6 the wound is ignored.
Distortion field: This model has a 4+ invulnerable save against ranged attacks.

Designer’s note: Before the battle, if you don’t have a base for this model, both players must agree the footprint of this model as if it had a base.
FACTION KEYWORDS: AELDARI, ASURYANI, WARHOST, <CRAFTWORLD>
KEYWORDS: VEHICLE, AIRCRAFT, FLY, TITANIC, VAMPIRE, VAMPIRE HUNTER

Datasheet-related Stratagems

1CP

CLOUDSTRIKE

Craftworlds Stratagem

The Asuryani often deploy Falcons and Wave Serpents in the lower atmosphere rather than on the ground. At a signal, they strike before the enemy have a chance to react.

Use this Stratagem during deployment if you have not used the Webway Strike Stratagem this battle. You can set up an ASURYANI VEHICLE unit from your army that can FLY in the clouds instead of placing it on the battlefield. It can descend at the end of any of your Movement phases – set it up anywhere on the battlefield more than 9" from any enemy units. If you use this Stratagem on a transport, all units embarked inside it remain so when it is set up in the clouds.
2CP

LIGHTNING-FAST REACTIONS

Craftworlds Stratagem

The Aeldari can process thoughts and emotions with baffling speed, making their physical reactions so fast that it seems they are able to dodge out of the way attacks and blows that would have hit any other target.

Use this Stratagem when a friendly ASURYANI INFANTRY unit, or a friendly ASURYANI UNIT WITH THE FLY keyword, is targeted by a ranged or melee weapon. Subtract 1 from all hit rolls made against that unit for the rest of the phase.

This datasheet has Flyers Battlefield Role. Full list of Craftworlds units sharing same Battlefield Role follows:

HEAVY
Heavy weapons are amongst the biggest guns on the battlefield, but they require bracing to fire at full effect and are unwieldy to bring to bear at close quarters.
When an INFANTRY model shoots a Heavy weapon, subtract 1 from the hit rolls when resolving that weapon’s attacks if the firing model’s unit has moved for any reason this turn (e.g. it made a Normal Move this turn).

  • Subtract 1 from hit rolls if firing model is INFANTRY and its unit has moved this turn.

Twin pulse laser used in following datasheets:

HEAVY
Heavy weapons are amongst the biggest guns on the battlefield, but they require bracing to fire at full effect and are unwieldy to bring to bear at close quarters.
When an INFANTRY model shoots a Heavy weapon, subtract 1 from the hit rolls when resolving that weapon’s attacks if the firing model’s unit has moved for any reason this turn (e.g. it made a Normal Move this turn).

  • Subtract 1 from hit rolls if firing model is INFANTRY and its unit has moved this turn.
HEAVY
Heavy weapons are amongst the biggest guns on the battlefield, but they require bracing to fire at full effect and are unwieldy to bring to bear at close quarters.
When an INFANTRY model shoots a Heavy weapon, subtract 1 from the hit rolls when resolving that weapon’s attacks if the firing model’s unit has moved for any reason this turn (e.g. it made a Normal Move this turn).

  • Subtract 1 from hit rolls if firing model is INFANTRY and its unit has moved this turn.
Flying
If a unit’s datasheet has the FLY keyword, then when it makes a Normal Move, an Advance or it Falls Back, its models can be moved across other models (and their bases) as if they were not there, and they can be moved within Engagement Range of enemy models. In addition, any vertical distance up and/or down that they make as part of that move is ignored. However, these models cannot finish their move either on top of another model (or its base) or within Engagement Range of any enemy models.

  • FLY models can move over other models when they make a Normal Move, an Advance or when they Fall Back.
  • FLY models ignore vertical distances when they make a Normal Move, an Advance or when they Fall Back.
Hit Roll
When a model makes an attack, make one hit roll for that attack by rolling one D6. If the result of the hit roll is equal to or greater than the attacking model’s Ballistic Skill (BS) characteristic (if the attack is being made with a ranged weapon) or its Weapon Skill (WS) characteristic (if the attack is being made with a melee weapon), then that attack scores one hit against the target unit. If not, the attack fails and the attack sequence ends.

If an attack is made with a weapon that has an ability that says it ‘automatically hits the target’, no hit roll is made – that attack simply scores one hit on the target unit. An unmodified hit roll of 6 always scores a hit, and an unmodified hit roll of 1 always fails. A hit roll can never be modified by more than -1 or +1. This means that if, after all the cumulative modifiers to a hit roll have been calculated, the total modifier would be -2 or worse, it is changed to be -1. Similarly, if, after all the cumulative modifiers to a hit roll have been calculated, the total modifier would be +2 or better, it is changed to be +1.
Advance
When a unit makes an Advance, make an Advance roll for the unit by rolling one D6. Add the result in inches to the Move (M) characteristic of each model in that unit until the end of the current phase. Each model in that unit can then move a distance in inches equal to or less than this total, but no model can be moved within Engagement Range of enemy models. A unit cannot shoot or declare a charge in the same turn that it made an Advance.

  • Advance: Models move up to M+D6".
  • Cannot move within Engagement Range of enemy models.
  • Units that Advance cannot shoot or charge this turn.
Mortal Wounds
Some attacks inflict mortal wounds – these are so powerful that no armour or force field can withstand their fury. Each mortal wound inflicts 1 point of damage on the target unit, and they are always applied one at a time. Do not make a wound roll or saving throw (including invulnerable saves) against a mortal wound – just allocate it as you would any other attack and inflict damage to a model in the target unit. Unlike damage inflicted by normal attacks, excess damage from mortal wounds is not lost. Instead, keep allocating damage to another model in the target unit until either all the damage has been allocated or the target unit is destroyed.

If an attack inflicts mortal wounds in addition to the normal damage, resolve the normal damage first. If an attack inflicts mortal wounds in addition to the normal damage, but the normal damage is subsequently saved, the target unit still suffers the mortal wounds, as described before. If an ability modifies the damage inflicted by a weapon, and that weapon can inflict mortal wounds in addition to the normal damage, the modifier does not apply to any mortal wounds that are inflicted (unless the rule specifically states otherwise).

  • Each mortal wound inflicted on a unit causes one model in the unit to lose one wound.
  • No saving throws can be made against mortal wounds.
  • Mortal wounds inflicted by attacks in addition to normal damage always apply, even if normal damage saved.
HEAVY
Heavy weapons are amongst the biggest guns on the battlefield, but they require bracing to fire at full effect and are unwieldy to bring to bear at close quarters.
When an INFANTRY model shoots a Heavy weapon, subtract 1 from the hit rolls when resolving that weapon’s attacks if the firing model’s unit has moved for any reason this turn (e.g. it made a Normal Move this turn).

  • Subtract 1 from hit rolls if firing model is INFANTRY and its unit has moved this turn.
ASSAULT
Assault weapons fire so rapidly or indiscriminately that they can be shot from the hip as warriors dash forwards into combat.
If a unit includes any models equipped with Assault weapons, that unit is still eligible to shoot with in your Shooting phase even if it has Advanced this turn, but you can only resolve attacks using those Assault weapons when you select that unit to shoot with. If a model shoots an Assault weapon in the same turn in which its unit has Advanced, subtract 1 from hit rolls when resolving that weapon’s attacks.

  • Can be shot even if firing model’s unit Advanced.
  • Subtract 1 from hit rolls if the firing model’s unit Advanced.
Saving Throw
The player commanding the target unit then makes one saving throw by rolling one D6 and modifying the roll by the Armour Penetration (AP) characteristic of the weapon that the attack was made with. For example, if the weapon has an AP of -1, then 1 is subtracted from the saving throw roll. If the result is equal to, or greater than, the Save (Sv) characteristic of the model the attack was allocated to, then the saving throw is successful and the attack sequence ends. If the result is less than the model’s Save characteristic, then the saving throw fails and the model suffers damage. An unmodified roll of 1 always fails.
Invulnerable Saves
Some models have an invulnerable save. Each time an attack is allocated to a model with an invulnerable save, you can choose to use either its normal Save (Sv) characteristic or its invulnerable save, but not both. If a model has more than one invulnerable save, it can only use one of them – choose which it will use. If you use a model’s invulnerable save, it is never modified by a weapon’s Armour Penetration value.

  • Invulnerable save: Saving throw that is never modified by attacking weapon’s AP.
  • A model with an invulnerable save can use it instead of its normal Sv.

The TITANIC keyword is used in following Craftworlds datasheets:

The VAMPIRE keyword is used in following Craftworlds datasheets:

© Vyacheslav Maltsev 2013-2021