Chaos Space Marines – Hell Blade
 ]
This datasheet does not meet the selection criteria (see Filter combo-box or Settings tab).
7

Hell Blade

NoNAME  M WS BS S T W A Ld Sv Base
135
Hell Blade (base: 120 x 92mm flying base)
1
135
Hell Blade
20"-60" 6+ 3+ 6 6 9 2 8 3+ 120 x 92mm flying base
A Hell Blade is equipped with: 2 twin autocannons.
WEAPON
RANGE
TYPE
S
AP
D
ABILITIES 
Lascannon
Lascannon
48"
Heavy 1
9
-3
D6
-
Twin autocannon
Twin autocannon
48"
Heavy 4
7
-1
2
-
WARGEAR OPTIONS
WARGEAR OPTIONS
 • This model’s 2 twin autocannons can be replaced with 2 lascannons.
ABILITIES
ABILITIES
Airborne: You cannot declare a charge with this model, and it can only be chosen as a target of a charge if the unit making the charge can FLY. You can only fight with this model if it is within Engagement Range of any enemy units that can FLY, and this model can only make melee attacks against units that can FLY. Enemy units can only make melee attacks against this model if they can FLY.
Hard to Hit: Each time a ranged attack is made against this model, subtract 1 from that attack’s hit roll.
Baleful Aberration: This model has a 5+ invulnerable save.
Explodes: When this model is destroyed, roll one D6 before removing it from play. On a 6 it explodes, and each unit within 6" suffers D3 mortal wounds.
Supersonic: Each time this model makes a Normal Move, Advances or Falls Back, first pivot it on the spot up to 90° (this does not contribute to how far the model moves), then move the model straight forwards. It cannot pivot again after the initial pivot.
FACTION KEYWORDS: CHAOS, , HERETIC ASTARTES,
KEYWORDS: VEHICLE, AIRCRAFT, FLY, HELL BLADE

Datasheet-related Stratagems

TANK HUNTERS1CP
Iron Warriors – Battle Tactic Stratagem

No armour is safe from the guns of the IV Legion.

Use this Stratagem in your Shooting phase or the Fight phase, when you choose an IRON WARRIORS unit from your army (excluding CHAOS CULTISTS) to shoot or fight with. Select one enemy VEHICLE unit. Until the end of that phase, when resolving an attack made by a model in that IRON WARRIORS unit against the selected unit, you can re-roll the wound roll.
UNHOLY VIGOUR1CP
Iron Warriors – Epic Deed Stratagem

The corrupted machine spirits of the IV refuse to yield.

Use this Stratagem at the start of your Movement phase. Select one IRON WARRIORS VEHICLE model from your army. That model regains up to 3 lost wounds.
1CP

BLASPHEMOUS MACHINES

Chaos Space Marines Stratagem

Heretic Astartes vehicles can be goaded to fury like wild beasts.

Use this Stratagem just before a HERETIC ASTARTES VEHICLE attacks in the Shooting phase. Until the end of the phase, that vehicle can ignore the penalties for moving and firing Heavy weapons, or for Advancing and firing Assault weapons.
HEAVY
Heavy weapons are amongst the biggest guns on the battlefield, but they require bracing to fire at full effect and are unwieldy to bring to bear at close quarters.
When an INFANTRY model shoots a Heavy weapon, subtract 1 from the hit rolls when resolving that weapon’s attacks if the firing model’s unit has moved for any reason this turn (e.g. it made a Normal Move this turn).

  • Subtract 1 from hit rolls if firing model is INFANTRY and its unit has moved this turn.
ASSAULT
Assault weapons fire so rapidly or indiscriminately that they can be shot from the hip as warriors dash forwards into combat.
If a unit includes any models equipped with Assault weapons, that unit is still eligible to shoot with in your Shooting phase even if it has Advanced this turn, but you can only resolve attacks using those Assault weapons when you select that unit to shoot with. If a model shoots an Assault weapon in the same turn in which its unit has Advanced, subtract 1 from hit rolls when resolving that weapon’s attacks.

  • Can be shot even if firing model’s unit Advanced.
  • Subtract 1 from hit rolls if the firing model’s unit Advanced.
Hit Roll
When a model makes an attack, make one hit roll for that attack by rolling one D6. If the result of the hit roll is equal to or greater than the attacking model’s Ballistic Skill (BS) characteristic (if the attack is being made with a ranged weapon) or its Weapon Skill (WS) characteristic (if the attack is being made with a melee weapon), then that attack scores one hit against the target unit. If not, the attack fails and the attack sequence ends.

If an attack is made with a weapon that has an ability that says it ‘automatically hits the target’, no hit roll is made – that attack simply scores one hit on the target unit. An unmodified hit roll of 6 always scores a hit, and an unmodified hit roll of 1 always fails. A hit roll can never be modified by more than -1 or +1. This means that if, after all the cumulative modifiers to a hit roll have been calculated, the total modifier would be -2 or worse, it is changed to be -1. Similarly, if, after all the cumulative modifiers to a hit roll have been calculated, the total modifier would be +2 or better, it is changed to be +1.
Mortal Wounds
Some attacks inflict mortal wounds – these are so powerful that no armour or force field can withstand their fury. Each mortal wound inflicts 1 point of damage on the target unit, and they are always applied one at a time. Do not make a wound roll or saving throw (including invulnerable saves) against a mortal wound – just allocate it as you would any other attack and inflict damage to a model in the target unit. Unlike damage inflicted by normal attacks, excess damage from mortal wounds is not lost. Instead, keep allocating damage to another model in the target unit until either all the damage has been allocated or the target unit is destroyed.

If an attack inflicts mortal wounds in addition to the normal damage, resolve the normal damage first. If an attack inflicts mortal wounds in addition to the normal damage, but the normal damage is subsequently saved, the target unit still suffers the mortal wounds, as described before. If an ability modifies the damage inflicted by a weapon, and that weapon can inflict mortal wounds in addition to the normal damage, the modifier does not apply to any mortal wounds that are inflicted (unless the rule specifically states otherwise).

  • Each mortal wound inflicted on a unit causes one model in the unit to lose one wound.
  • No saving throws can be made against mortal wounds.
  • Mortal wounds inflicted by attacks in addition to normal damage always apply, even if normal damage saved.
Wound Roll
Each time an attack scores a hit against a target unit, make a wound roll for that attack by rolling one D6 to see if that attack successfully wounds the target. The result required is determined by comparing the attacking weapon’s Strength (S) characteristic with the target’s Toughness (T) characteristic, as shown on the following table:

WOUND ROLL
ATTACK’S STRENGTH vs TARGET’S TOUGHNESSD6 ROLL REQUIRED
Is the Strength TWICE (or more) than the Toughness?2+
Is the Strength GREATER than the Toughness?3+
Is the Strength EQUAL to the Toughness?4+
Is the Strength LOWER than the Toughness?5+
Is the Strength HALF (or less) than the Toughness?6+

If the result of the wound roll is less than the required number, the attack fails and the attack sequence ends. An unmodified wound roll of 6 always successfully wounds the target, and an unmodified wound roll of 1 always fails. A wound roll can never be modified by more than -1 or +1. This means that if, after all the cumulative modifiers to a wound roll have been calculated, the total modifier would be -2 or worse, it is changed to be -1. Similarly, if, after all the cumulative modifiers to a wound roll have been calculated, the total modifier would be +2 or better, it is changed to be +1.
Saving Throw
The player commanding the target unit then makes one saving throw by rolling one D6 and modifying the roll by the Armour Penetration (AP) characteristic of the weapon that the attack was made with. For example, if the weapon has an AP of -1, then 1 is subtracted from the saving throw roll. If the result is equal to, or greater than, the Save (Sv) characteristic of the model the attack was allocated to, then the saving throw is successful and the attack sequence ends. If the result is less than the model’s Save characteristic, then the saving throw fails and the model suffers damage. An unmodified roll of 1 always fails.
Invulnerable Saves
Some models have an invulnerable save. Each time an attack is allocated to a model with an invulnerable save, you can choose to use either its normal Save (Sv) characteristic or its invulnerable save, but not both. If a model has more than one invulnerable save, it can only use one of them – choose which it will use. If you use a model’s invulnerable save, it is never modified by a weapon’s Armour Penetration value.

  • Invulnerable save: Saving throw that is never modified by attacking weapon’s AP.
  • A model with an invulnerable save can use it instead of its normal Sv.

The CHAOS CULTISTS keyword is used in the following Chaos Space Marines datasheets:

Advance
When a unit makes an Advance, make an Advance roll for the unit by rolling one D6. Add the result in inches to the Move (M) characteristic of each model in that unit until the end of the current phase. Each model in that unit can then move a distance in inches equal to or less than this total, but no model can be moved within Engagement Range of enemy models. A unit cannot shoot or declare a charge in the same turn that it made an Advance.

  • Advance: Models move up to M+D6".
  • Cannot move within Engagement Range of enemy models.
  • Units that Advance cannot shoot or charge this turn.
Army List
Datasheets collated
Engagement Range
Engagement Range represents the zone of threat that models present to their enemies. While a model is within 1" horizontally and 5" vertically of an enemy model, those models are within Engagement Range of each other. While two enemy models are within Engagement Range of each other, those models’ units are also within Engagement Range of each other. Models cannot be set up within Engagement Range of enemy models.

  • Engagement Range: 1" horizontally + 5" vertically.
  • Models cannot be set up within Engagement Range of enemy models.
Charging with a Unit
Once you have chosen an eligible unit to declare a charge with, you must select one or more enemy units within 12" of it as the targets of its charge. The target(s) of this charge do not need to be visible to the charging unit. You then make a charge roll for your unit by rolling 2D6. This is the maximum number of inches each model in the charging unit can now be moved if they can make the charge move. To make a charge move, the unit’s charge roll must be sufficient that it is able to end that move in unit coherency and within Engagement Range of every unit that was a target of its charge, without moving within Engagement Range of any enemy units that were not a target of its charge. If this is possible, then the charge is successful and the models in the unit make a charge move so as to fulfil the above conditions. If this is impossible, the charge fails and no models in the charging unit move this phase.

  • Declare targets of the charge (must be within 12").
  • Charge roll = 2D6".
  • If insufficient to move charging unit into Engagement Range of all targets, charge fails.
  • If charge successful, models make their charge move.
  • Cannot make a charge move within Engagement Range of any unit that was not the target of the charge.
Fall Back
When a unit Falls Back, each model in that unit can move a distance in inches equal to or less than the Move (M) characteristic shown on its datasheet, and when doing so you can move it within Engagement Range of enemy models, but it cannot end its move within Engagement Range of any enemy models – if it cannot do this then it cannot Fall Back. A unit cannot declare a charge in the same turn that it Fell Back. A unit cannot shoot or attempt to manifest a psychic power in the same turn that it Fell Back unless it is TITANIC.

  • Fall Back: Models move up to M".
  • Units that Fall Back cannot charge this turn.
  • Units that Fall Back cannot shoot or manifest psychic powers this turn unless they are TITANIC.
Normal Move
When a unit makes a Normal Move, each model in that unit can move a distance in inches equal to or less than the Move (M) characteristic shown on its datasheet, but no model can be moved within Engagement Range of enemy models.

  • Normal Move: Models move up to M".
  • Cannot move within Engagement Range of any enemy models.
Flying
If a unit’s datasheet has the FLY keyword, then when it makes a Normal Move, an Advance or it Falls Back, its models can be moved across other models (and their bases) as if they were not there, and they can be moved within Engagement Range of enemy models. In addition, any vertical distance up and/or down that they make as part of that move is ignored. However, these models cannot finish their move either on top of another model (or its base) or within Engagement Range of any enemy models.

  • FLY models can move over other models when they make a Normal Move, an Advance or when they Fall Back.
  • FLY models ignore vertical distances when they make a Normal Move, an Advance or when they Fall Back.

Lascannon used in the following datasheets:


– may take Lascannon as an option.

This datasheet has Flyers Battlefield Role. Full list of Chaos Space Marines units sharing same Battlefield Role follows:

© Vyacheslav Maltsev 2013-2021