Astra Militarum – Salamander Scout Tanks
 ]
This datasheet does not meet the selection criteria (see Filter combo-box or Settings tab).
4

Salamander Scout Tanks*

NoNAME  M WS BS S T W! A Ld Sv Base
75
Salamander Scout Tank (base: Use model)
1‑3
75
Salamander Scout Tank
12" 6+ 4+ 6 7 6-10 3 7 3+ Use model
8" 6+ 5+ 6 7 3-5 D3 7 3+
4" 6+ 6+ 6 7 1-2 1 7 3+
If this unit contains 2 models, it has Power Rating 6. If it contains 3 models, it has Power Rating 9. Every model is equipped with: autocannon; heavy bolter.
* This datasheet is part of the Warhammer Legends range of rules and can be used in any type of play - open, narrative or matched. However Legends units are not updated by GW and not supported by Wahapedia and therefore not recommended for competitive tournaments.
WEAPON
RANGE
TYPE
S
AP
D
ABILITIES 
Autocannon
Autocannon
48"
Heavy 2
7
-1
2
-
Heavy bolter
Heavy bolter
36"
Heavy 3
5
-1
2
-
+5
Heavy stubber
+5
Heavy stubber
36"
Heavy 3
4
0
1
-
+5
Hunter-killer missile
+5
Hunter-killer missile
48"
Heavy 1
10
-2
D6
The bearer can only shoot with each hunter-killer missile it is equipped with once per battle.
The bearer can only shoot with each hunter-killer missile it is equipped with once per battle.
+3
Storm bolter
+3
Storm bolter
24"
Rapid Fire 2
4
0
1
-
WARGEAR OPTIONS
WARGEAR OPTIONS
 • Any number of models can each be equipped with 1 hunter-killer missile.
 • Any number of models can each be equipped with one of the following: 1 heavy stubber; 1 storm bolter.
ABILITIES
ABILITIES
Scout Vehicle: At the start of the first battle round but before the first turn begins, you can move this unit up to 9". It cannot end this move within 9" of any enemy models.
Smoke Launchers: Once per game, instead of shooting any weapons in the Shooting phase, this unit can use its smoke launchers; until your next Shooting phase your opponent must subtract 1 from all hit rolls for ranged weapons that target it.
Vehicle Squadron: When this unit is first set up on the battlefield, its models do not have to be set up in unit coherency. Instead, each model must be set up within 6" of one other model from its unit. From that point on, each model in this unit is treated as a separate unit.
Explodes: When this model is destroyed, roll one D6 before removing it from play. On a 6 it explodes, and each unit within 6" suffers D3 mortal wounds.
FACTION KEYWORDS: IMPERIUM, , <REGIMENT>
KEYWORDS: VEHICLE, SALAMANDER SCOUT TANKS

Datasheet-related Stratagems

DEFENSIVE FIRE1CP
Astra Militarum – Boarding Actions – Battle Tactic Stratagem

Astra Militarum troops are often trained in holding ground and unleashing decisive defensive volleys.

Use this Stratagem when an unit from your army completes the Set Overwatch action. Until the end of your opponent’s next turn, while that unit Sets Overwatch, it also Holds Steady.
RELENTLESS1CP/2CP
Astra Militarum – Epic Deed Stratagem

Astra Militarum vehicles are so rugged and robust that damaged systems can be temporarily pushed beyond their limits in extremis.

Use this Stratagem in your Command phase. Select one VEHICLE model from your army. Until the start of your next Command phase, that model is considered to have its full wounds remaining for the purposes of determining what characteristics on its profile to use. If that model has the TITANIC keyword, this Stratagem costs 2CP; otherwise, it costs 1CP.
ACCEPTABLE LOSSES1CP
Astra Militarum – Strategic Ploy Stratagem

Sacrifices must be made on the field of war, and ruthless officers willingly give the order to unleash firestorms even at the risk of their own troops’ lives.

Use this Stratagem in your Shooting phase. Select one unit from your army that is not within Engagement Range of any enemy units, then select one enemy unit. Until the end of the phase, models in that unit can target that enemy unit even if it is within Engagement Range of other friendly PLATOON or GRIM DEMEANOUR units, but each time a model makes an attack against such a target, that attack’s hit roll cannot be re-rolled and on an unmodified hit roll of 1, resolve that attack against one friendly unit, selected by you, that is within Engagement Range of the target instead (resolve any attacks against friendly units after resolving all of the attacks against that enemy unit).
VICIOUS TRAPS1CP
Astra Militarum – Strategic Ploy Stratagem

Specially trained soldiers lace the ground ahead of their defences with all manner of incendiary charges, mines and razored snares.

Use this Stratagem in your opponent’s Charge phase, when an enemy unit finishes a charge move within Engagement Range of one or more units from your army that are wholly within an Area Terrain feature. Roll one D6 and apply the following modifiers:
  • +1 if any of those units from your army have the CATACHAN or VETERAN GUERRILLAS keyword.
  • +1 if any of those units from your army have the MELTA MINE keyword.
  • +1 if your army includes SLY MARBO and he is on the battlefield.
On a 2-5, that enemy unit suffers D3 mortal wounds; on a 6+, that enemy unit suffers 2D3 mortal wounds.
Set Overwatch
One or more units from your army can start to perform this action at the end of the Move Units step of your Movement phase. The action is completed at the end of your turn. If completed, until the end of your opponent’s next turn, that unit is said to have Set Overwatch. Each time an enemy unit is set up on the battlefield or ends a Normal Move, an Advance move, a Fall Back move, a charge move, or opens a Hatchway, units from your army that have Set Overwatch can fire Overwatch at that enemy unit.

Overwatch is resolved like a normal shooting attack except that models can only target the enemy unit that has just finished moving, and an unmodified hit roll of 6 is always required for a successful hit roll, irrespective of the firing model’s Ballistic Skill or any modifiers. A unit cannot fire Overwatch while enemy units are within Engagement Range of it unless it is firing Overwatch at an enemy unit that has just finished making a charge move within Engagement Range of it. In this case it can do so even if other friendly units are within Engagement Range of the same enemy unit, and it can do so with any ranged weapon it is equipped with (excluding weapons with the Blast ability).

After a unit has fired Overwatch, it must complete the Set Overwatch action again before it can fire Overwatch again.
Hold Steady
Some rules will allow a unit to Hold Steady. If a model makes an Overwatch attack while its unit is under the effects of such a rule, an unmodified hit roll of 5+ for that attack will score a hit.
Engagement Range
Engagement Range represents the zone of threat that models present to their enemies. While a model is within 1" horizontally and 5" vertically of an enemy model, those models are within Engagement Range of each other. While two enemy models are within Engagement Range of each other, those models’ units are also within Engagement Range of each other. Models cannot be set up within Engagement Range of enemy models.

  • Engagement Range: 1" horizontally + 5" vertically.
  • Models cannot be set up within Engagement Range of enemy models.
Hit Roll
When a model makes an attack, make one hit roll for that attack by rolling one D6. If the result of the hit roll is equal to or greater than the attacking model’s Ballistic Skill (BS) characteristic (if the attack is being made with a ranged weapon) or its Weapon Skill (WS) characteristic (if the attack is being made with a melee weapon), then that attack scores one hit against the target unit. If not, the attack fails and the attack sequence ends.

If an attack is made with a weapon that has an ability that says it ‘automatically hits the target’, no hit roll is made – that attack simply scores one hit on the target unit. An unmodified hit roll of 6 always scores a hit, and an unmodified hit roll of 1 always fails. A hit roll can never be modified by more than -1 or +1. This means that if, after all the cumulative modifiers to a hit roll have been calculated, the total modifier would be -2 or worse, it is changed to be -1. Similarly, if, after all the cumulative modifiers to a hit roll have been calculated, the total modifier would be +2 or better, it is changed to be +1.
Re-rolls
Some rules allow you to re-roll a dice roll, which means you get to roll some or all of the dice again. If a rule allows you to re-roll a dice roll that was made by adding several dice together (2D6, 3D6 etc.) then, unless otherwise stated, you must re-roll all of those dice again. If a rule allows you to re-roll specific dice results, only those dice can be re-rolled. If a rule allows you to re-roll a specific dice result, but the result is obtained by halving a D6 (such as when rolling a D3), you use the value of the halved roll to determine if it can be re-rolled, not the value of the original D6. For example, if a rule states to re-roll results of 1, and you roll a D3, you would re-roll if the D6 rolled a 1 or a 2 (which is then halved to get a D3 value of a 1).

You can never re-roll a dice more than once, and re-rolls happen before modifiers (if any) are applied. Rules that refer to the value of an ‘unmodified’ dice roll are referring to the dice result after any re-rolls, but before any modifiers are applied.

  • Re-roll: Roll dice again.
  • Re-rolls are applied before modifiers (if any).
  • A dice can never be re-rolled more than once.
  • Unmodified dice: Result of roll after re-rolls, but before modifiers (if any).
Charging with a Unit
Once you have chosen an eligible unit to declare a charge with, you must select one or more enemy units within 12" of it as the targets of its charge. The target(s) of this charge do not need to be visible to the charging unit. You then make a charge roll for your unit by rolling 2D6. This is the maximum number of inches each model in the charging unit can now be moved if they can make the charge move. To make a charge move, the unit’s charge roll must be sufficient that it is able to end that move in unit coherency and within Engagement Range of every unit that was a target of its charge, without moving within Engagement Range of any enemy units that were not a target of its charge. If this is possible, then the charge is successful and the models in the unit make a charge move so as to fulfil the above conditions. If this is impossible, the charge fails and no models in the charging unit move this phase.

  • Declare targets of the charge (must be within 12").
  • Charge roll = 2D6".
  • If insufficient to move charging unit into Engagement Range of all targets, charge fails.
  • If charge successful, models make their charge move.
  • Cannot make a charge move within Engagement Range of any unit that was not the target of the charge.

The CATACHAN keyword is used in the following Astra Militarum datasheets:

The MELTA MINE keyword is used in the following Astra Militarum datasheets:


– if equipped with the Melta mine the bearer gains the MELTA MINE keyword.

The SLY MARBO keyword is used in the following Astra Militarum datasheets:

Elites
Mortal Wounds
Some attacks inflict mortal wounds – these are so powerful that no armour or force field can withstand their fury. Each mortal wound inflicts 1 point of damage on the target unit, and they are always applied one at a time. Do not make a wound roll or saving throw (including invulnerable saves) against a mortal wound – just allocate it as you would any other attack and inflict damage to a model in the target unit. Unlike damage inflicted by normal attacks, excess damage from mortal wounds is not lost. Instead, keep allocating damage to another model in the target unit until either all the damage has been allocated or the target unit is destroyed.

If an attack inflicts mortal wounds in addition to the normal damage, resolve the normal damage first. If an attack inflicts mortal wounds in addition to the normal damage, but the normal damage is subsequently saved, the target unit still suffers the mortal wounds, as described before. If an ability modifies the damage inflicted by a weapon, and that weapon can inflict mortal wounds in addition to the normal damage, the modifier does not apply to any mortal wounds that are inflicted (unless the rule specifically states otherwise).

  • Each mortal wound inflicted on a unit causes one model in the unit to lose one wound.
  • No saving throws can be made against mortal wounds.
  • Mortal wounds inflicted by attacks in addition to normal damage always apply, even if normal damage saved.
Army List
Datasheets collated

Disable Ads



Boosty subscribers may disable ads:
1. Enter e-mail you have used to login on Boosty.
2. Press Get pin code button (if you don’t have it already)
3. Enter pin code.

Note that login database updated once a day. So, if you are a new booster - try tomorrow. And thank you!
HEAVY
Heavy weapons are amongst the biggest guns on the battlefield, but they require bracing to fire at full effect and are unwieldy to bring to bear at close quarters.
When an INFANTRY model shoots a Heavy weapon, subtract 1 from the hit rolls when resolving that weapon’s attacks if the firing model’s unit has moved for any reason this turn (e.g. it made a Normal Move this turn).

  • Subtract 1 from hit rolls if firing model is INFANTRY and its unit has moved this turn.
RAPID FIRE
Rapid fire weapons are versatile armaments capable of aimed single shots at long range or controlled bursts of fire at close quarters.
When a model shoots a Rapid Fire weapon, double the number of attacks it makes if its target is within half the weapon’s range.

  • Double number of attacks made if target is within half range.
Unit Coherency
A unit that has more than one model must be set up and finish any sort of move as a single group, with all models within 2" horizontally and 5" vertically of at least one other model from their unit. While a unit has six or more models, all models must instead be within 2" horizontally and 5" vertically of at least two other models from their unit. This is called unit coherency. If a unit cannot end any kind of move in unit coherency, that move cannot be made. Units are primarily moved in the Movement phase, but they can also be moved in the Charge phase and the Fight phase.

Some rules allow you to add models to a unit during the battle; such models must always be set up in unit coherency with the unit they are being added to. Sometimes there will be insufficient room to set up all the models from a unit, or it will not be possible to set up all the models so that they are in unit coherency. When this is the case, any models that cannot be set up are considered to have been destroyed.

  • Unit coherency: 2" horizontally + 5" vertically.
  • Each model must be in unit coherency with one other model from own unit.
  • While unit has 6+ models, each model must be in unit coherency with 2 other models from own unit.
© Vyacheslav Maltsev 2013-2023