Astra Militarum – Crusaders
 ]
This datasheet does not meet the selection criteria (see Filter combo-box or Settings tab).
2

Crusaders

NoNAME  M WS BS S T W A Ld Sv Base
16
Crusader (base: 25mm)
2‑10
16
Crusader
6" 3+ 4+ 3 3 1 2 7 4+ 25mm
This unit contains 2 Crusaders. It may contain up to 2 additional Crusaders (Power Rating +2), up to 4 additional Crusaders (Power Rating +4), up to 6 additional Crusaders (Power Rating +6) or up to 8 additional Crusaders (Power Rating +8). Each Crusader is armed with a power sword.
WEAPON
RANGE
TYPE
S
AP
D
ABILITIES 
Power sword
Power sword
Melee
Melee
+1
-3
1
-
ABILITIES
ABILITIES
Unquestioning Loyalty
Acts of Faith: Roll a D6 at the start of each of your turns. On a roll of 2+, one unit from your army with this ability can perform an Act of Faith chosen from the following list.

Hand of the Emperor: The unit can immediately move as if it were the Movement phase.

Divine Guidance: The unit can immediately shoot as if it were the Shooting phase.

The Passion: The unit can, if it is within 1" of an enemy unit, immediately pile in and attack as if it were the Fight phase.

Spirit of the Martyr: One model in the unit recovers D3 lost wounds, or you can return a single slain model to the unit with 1 wound remaining.
Shield of Faith: Models in this unit have a 6+ invulnerable save. In addition, this unit can attempt to deny one psychic power in each enemy Psychic phase in the same manner as a PSYKER. However, if it does so, instead of rolling 2D6, only roll a single D6; the psychic power is resisted if the roll is greater than the result of the Psychic test that manifested the power. When attempting to deny a psychic power, first select a model in the unit – measure range, visibility etc. from this model.
Zealot: You can re-roll failed hit rolls for a unit with this ability in a turn in which it charged, made a heroic intervention, or was charged by an enemy unit.
Storm Shield: The bearer has a 4+ invulnerable save. In addition, add 1 to armour saving throws made for the bearer.
FACTION KEYWORDS: IMPERIUM, ASTRA MILITARUM, ADEPTUS MINISTORUM, BROOD BROTHERS
KEYWORDS: INFANTRY, CRUSADERS

Datasheet-related Stratagems

1CP

EMPEROR’S CONCLAVE INFANTRY COMPANY

Specialist Detachment Stratagem

Regiments raised from shrine worlds and other centres of the Imperial Creed have an unshakeable faith in the Emperor.

Use this Stratagem when choosing your army. Pick an ASTRA MILITARUM Detachment from your army to be an Emperor’s Conclave Specialist Detachment. COMPANY COMMANDERS, PLATOON COMMANDERS, COMMAND SQUADS, INFANTRY SQUADS, CONSCRIPTS, MINISTORUM PRIESTS and CRUSADERS units in that Detachment gain the EMPEROR’S CONCLAVE keyword.
1CP

TAKE COVER!

Astra Militarum Stratagem

Sometimes the only possible response to overwhelming enemy fire is to hit the dirt and wait for the storm to pass, before springing up to unleash an answering volley.

Use this Stratagem in your opponent’s Shooting phase when your opponent selects one of your ASTRA MILITARUM INFANTRY units as a target. You can add 1 to armour saving throws you make for this unit until the end of the phase.
1CP

FIGHT TO THE DEATH

Astra Militarum Stratagem

They may be mere mortals in a galaxy of gods and monsters, but the soldiers of the Astra Militarum stand tall in the face of obliteration, lasguns blazing.

Use this Stratagem at the start of the Morale phase. Pick an ASTRA MILITARUM INFANTRY unit from your army that is required to take a Morale test. You can roll a D3 for the unit, rather than a D6, when taking this test.
Select Weapon
When a model makes a close combat attack, it must do so using a melee weapon (i.e. a weapon that has the ‘Melee’ type). The weapons a model is equipped with are described on its datasheet. If a model is not equipped with any melee weapons, or if it cannot make an attack with any of the melee weapons it is equipped with, then that model makes its attacks using a close combat weapon, which has the following profile:

WEAPONRANGETYPESAPD
Close combat weaponMeleeMeleeUser01

If a model has more than one melee weapon, select which it will use before resolving any attacks. If a model has more than one melee weapon and can make several attacks, it can split them between these weapons however you wish – declare which attacks are being made with which weapons before any attacks are resolved. If the selected weapon has more than one profile that you must choose between, you must declare which profile is being used at the same time. Different attacks made with such a weapon can be made using different profiles if you wish.

If your unit is making attacks with more than one melee weapon against a unit, and those weapons have different characteristics profiles, then after you have resolved an attack with one of those weapons you must, if any other weapons with the same characteristics profile are also being used to make attacks against that unit, resolve those attacks before resolving any attacks against the target with a weapon that has a different characteristics profile. Note that all the attacks you have declared are always resolved against the target unit even if, when you come to resolve an individual attack, no models in the target unit remain in range (this can happen because of models being destroyed and removed from the battlefield as the result of resolving other attacks made by the attacking model’s unit first).

  • Each close combat attack is made with a melee weapon.
  • A model makes attacks using the close combat weapon profile if it has no other melee weapons.
  • If a unit attacks with multiple weapons, all attacks made with weapons that have the same profile must be resolved before resolving attacks with the next.

The <CULT> and CHARACTER keywords are used in the following Genestealer Cults datasheets:

Unquestioning Loyalty

So fanatically devoted are Genestealer Cultists that they would die for their masters.

Each time you fail a saving throw for a <CULT> CHARACTER model, and each time a <CULT> CHARACTER model suffers a mortal wound, before inflicting damage check to see if it is within 3" of any friendly <CULT> or BROOD BROTHERS units with this ability. If it is, you can select one of those units and roll a D6; on a 4+ you do not inflict any damage on the character, but one model in the selected unit (your choice) is slain. Otherwise, the character suffers damage as normal.
Pile In
When a unit piles in, you can move each model in that unit up to 3" – this is a pile-in move. Each model in the unit must finish its pile-in move closer to the closest enemy model. A model that is already touching an enemy model cannot move, but still counts as having piled in. Remember that a unit must finish any type of move in unit coherency.

  • Pile in: Move up to 3".
  • Must end closer to the closest enemy model.
Saving Throw
The player commanding the target unit then makes one saving throw by rolling one D6 and modifying the roll by the Armour Penetration (AP) characteristic of the weapon that the attack was made with. For example, if the weapon has an AP of -1, then 1 is subtracted from the saving throw roll. If the result is equal to, or greater than, the Save (Sv) characteristic of the model the attack was allocated to, then the saving throw is successful and the attack sequence ends. If the result is less than the model’s Save characteristic, then the saving throw fails and the model suffers damage. An unmodified roll of 1 always fails.
Invulnerable Saves
Some models have an invulnerable save. Each time an attack is allocated to a model with an invulnerable save, you can choose to use either its normal Save (Sv) characteristic or its invulnerable save, but not both. If a model has more than one invulnerable save, it can only use one of them – choose which it will use. If you use a model’s invulnerable save, it is never modified by a weapon’s Armour Penetration value.

  • Invulnerable save: Saving throw that is never modified by attacking weapon’s AP.
  • A model with an invulnerable save can use it instead of its normal Sv.
Deny the Witch
When a PSYKER unit attempts to deny a psychic power, you must take a Deny the Witch test for that unit by rolling 2D6. If the total is greater than the result of the Psychic test, the Deny the Witch test is passed and the psychic power is denied. Only one attempt can be made to deny a psychic power. If a PSYKER unit can attempt to deny more than one psychic power in a psychic phase, this will be listed on its datasheet.

  • Deny the Witch: Passed if 2D6 exceeds result of the opposing PSYKER’s Psychic test.
  • Only one attempt can be made to deny each psychic power.
Psychic Tests
When a PSYKER unit attempts to manifest a psychic power, you must take a Psychic test for that unit by rolling 2D6. If the total is equal to or greater than that power’s warp charge value, the Psychic test is passed. If you roll a double 1 or a double 6 when taking a Psychic test, that unit immediately suffers Perils of the Warp.

  • Psychic test: Passed if 2D6 equals or exceeds psychic power’s warp charge.
  • If double 1 or double 6 rolled, PSYKER suffers Perils of the Warp.
Hit Roll
When a model makes an attack, make one hit roll for that attack by rolling one D6. If the result of the hit roll is equal to or greater than the attacking model’s Ballistic Skill (BS) characteristic (if the attack is being made with a ranged weapon) or its Weapon Skill (WS) characteristic (if the attack is being made with a melee weapon), then that attack scores one hit against the target unit. If not, the attack fails and the attack sequence ends.

If an attack is made with a weapon that has an ability that says it ‘automatically hits the target’, no hit roll is made – that attack simply scores one hit on the target unit. An unmodified hit roll of 6 always scores a hit, and an unmodified hit roll of 1 always fails. A hit roll can never be modified by more than -1 or +1. This means that if, after all the cumulative modifiers to a hit roll have been calculated, the total modifier would be -2 or worse, it is changed to be -1. Similarly, if, after all the cumulative modifiers to a hit roll have been calculated, the total modifier would be +2 or better, it is changed to be +1.
Performing a Heroic Intervention
When a unit performs a Heroic Intervention, you can move each model in that unit up to 3" – this is a Heroic Intervention move. Each model in the unit must finish its Heroic Intervention move closer to the closest enemy model. Remember that a unit must finish any type of move in unit coherency.

  • Heroic Intervention: Move up to 3".
  • Must end closer to the closest enemy model.
Saving Throw
The player commanding the target unit then makes one saving throw by rolling one D6 and modifying the roll by the Armour Penetration (AP) characteristic of the weapon that the attack was made with. For example, if the weapon has an AP of -1, then 1 is subtracted from the saving throw roll. If the result is equal to, or greater than, the Save (Sv) characteristic of the model the attack was allocated to, then the saving throw is successful and the attack sequence ends. If the result is less than the model’s Save characteristic, then the saving throw fails and the model suffers damage. An unmodified roll of 1 always fails.
Invulnerable Saves
Some models have an invulnerable save. Each time an attack is allocated to a model with an invulnerable save, you can choose to use either its normal Save (Sv) characteristic or its invulnerable save, but not both. If a model has more than one invulnerable save, it can only use one of them – choose which it will use. If you use a model’s invulnerable save, it is never modified by a weapon’s Armour Penetration value.

  • Invulnerable save: Saving throw that is never modified by attacking weapon’s AP.
  • A model with an invulnerable save can use it instead of its normal Sv.
Saving Throw
The player commanding the target unit then makes one saving throw by rolling one D6 and modifying the roll by the Armour Penetration (AP) characteristic of the weapon that the attack was made with. For example, if the weapon has an AP of -1, then 1 is subtracted from the saving throw roll. If the result is equal to, or greater than, the Save (Sv) characteristic of the model the attack was allocated to, then the saving throw is successful and the attack sequence ends. If the result is less than the model’s Save characteristic, then the saving throw fails and the model suffers damage. An unmodified roll of 1 always fails.

The ADEPTUS MINISTORUM keyword is used in the following Astra Militarum datasheets:

The CRUSADERS keyword is used in the following Astra Militarum datasheets:

The COMPANY COMMANDER keyword is used in the following Astra Militarum datasheets:

The PLATOON COMMANDER keyword is used in the following Astra Militarum datasheets:

The COMMAND SQUAD keyword is used in the following Astra Militarum datasheets:

The INFANTRY SQUAD keyword is used in the following Astra Militarum datasheets:

The CONSCRIPTS keyword is used in the following Astra Militarum datasheets:

The MINISTORUM PRIEST keyword is used in the following Astra Militarum datasheets:

The CRUSADERS keyword is used in the following Astra Militarum datasheets:

Saving Throw
The player commanding the target unit then makes one saving throw by rolling one D6 and modifying the roll by the Armour Penetration (AP) characteristic of the weapon that the attack was made with. For example, if the weapon has an AP of -1, then 1 is subtracted from the saving throw roll. If the result is equal to, or greater than, the Save (Sv) characteristic of the model the attack was allocated to, then the saving throw is successful and the attack sequence ends. If the result is less than the model’s Save characteristic, then the saving throw fails and the model suffers damage. An unmodified roll of 1 always fails.
Morale Tests
To take a Morale test, roll one D6 and add the number of models from the unit that have been destroyed this turn. If the result is equal to or less than the highest Leadership (Ld) characteristic in the unit, the Morale test is passed and nothing else happens. An unmodified roll of 1 also always results in a passed Morale test, irrespective of the total result. In any other case, the Morale test is failed, one model flees that unit, and you must then take Combat Attrition tests for the remaining models in the unit. You decide which model from your unit flees – that model is removed from play and counts as having been destroyed, but it never triggers any rules that are used when a model is destroyed.

  • Morale test = D6 + number of models destroyed this turn.
  • Unmodified roll of 1 always a success (no models flee).
  • If Morale test exceeds unit’s Ld, one model flees and other models must take Combat Attrition tests.
Army List
Datasheets collated
© Vyacheslav Maltsev 2013-2021