Gloomspite Gitz – Boggleye
This warscroll does not meet the selection criteria (see Settings tab).


Boggleyes stare deep into the souls of all those around them, chanting hypnotic mantras and revolving their pupils in an unlikely and hypnotic fashion. Their victims are swiftly reduced to slack-jawed puppets who obey the Boggleye’s every command.
MELEE WEAPONSRangeAttacksTo HitTo WoundTo WndRendDamageDmg
Mesmerising Staff
Mesmerising Staff1"14+3+-1D3

Unit Size: 1      Points: 190
Battlefield Role: None
Base size: 32mm
Notes: Single. Boggleye, Brewgit, Scaremonger, Shroomancer and Spiker must be taken as a set. Although taken as a set, each is a separate unit.


This warscroll can be used in the following warscroll battalions:
 • Gobbapalooza


A Boggleye is a single model armed with a Mesmerising Staff.


Hallucinogenic Fungus Brews: Gobbapalooza shamans drink long draughts of hallucinogenic fungus brew before the battle begins, making them almost impervious to pain. However, as the battle progresses the effects start to wear off.
In the first battle round, this unit has a ward of 5+. In the second battle round, this unit has a ward of 6+.

Slippery Git: Gobbapalooza shamans seek to put as many of their fellow grots between themselves and incoming enemy fire as possible.
Subtract 1 from hit rolls for attacks made with missile weapons that target this model while it is within 3" of a friendly MOONCLAN unit with 3 or more models.


This model is a WIZARD. It can attempt to cast one spell in your hero phase and attempt to unbind one spell in the enemy hero phase. It knows the Mesmerise spell.

Mesmerise: The Boggleye looks deep into the eyes of his victims. Friendly warriors are convinced to stand firm against whatever foe they face, while enemies are turned into slow-witted imbeciles.
Mesmerise has a casting value of 6. If successfully cast, pick 1 unit wholly within 12" of the caster that is visible to them. If that unit is a friendly unit, it does not take battleshock tests until your next hero phase. If that unit is an enemy unit, until your next hero phase that unit fights at the end of each combat phase, after the players have picked any other units to fight.

Hit Roll
Roll a dice. If the roll equals or beats the attacking weapon’s To Hit characteristic, the attack scores a hit and you must make a wound roll. If not, the attack fails and the attack sequence ends. An unmodified hit roll of 1 always fails and an unmodified hit roll of 6 always hits. A hit roll cannot be modified by more than +1 or -1 (this is an exception to the principle that abilities take precedence over core rules).

Sometimes an ability will allow a single hit roll to score two or more hits. If this is the case, make all of the wound and save rolls for those hits at the same time.
Army List
Warscrolls collated
13.1.1 Shooting Attacks
When a friendly unit shoots, you can make shooting attacks with any of the missile weapons the models in the unit are armed with that they are allowed to use (including missile weapons used by mounts).

The target of a shooting attack must be within a number of inches of the attacking model equal to the Range characteristic of the weapon being used to make the attack. The range must be measured to the closest visible model in the target unit (if you are unsure whether a model is visible, stoop down and take a look from behind the shooting model). Models can see through other models in their unit.

Some missile weapons have a Range characteristic with a minimum range (e.g. 6"-48"). Units wholly within the minimum range cannot be targeted with these weapons.
19.1 Casting Spells
In your hero phase, you can attempt to cast spells with friendly WIZARDS. You cannot attempt to cast the same spell more than once in the same hero phase, even with a different WIZARD. In order to attempt to cast a spell, pick a friendly WIZARD, say which of the spells that they know will be attempted, and then make a casting roll by rolling 2D6. If the casting roll is equal to or greater than the casting value of the spell, the spell is successfully cast.
19.1.2 Unbinding Spells
If a spell is successfully cast, your opponent can pick 1 of their WIZARDS that is within 30" of the caster to attempt to unbind the spell before its effects are applied. In order to attempt to unbind a spell, first say which WIZARD will attempt to unbind it. Then make an unbinding roll by rolling 2D6. If the unbinding roll is greater than the roll used to cast the spell, then the spell is unbound and its effects are not applied. The number of spells a WIZARD can attempt to unbind is noted on their warscroll. Only 1 unbinding attempt can be made for each spell.

The WIZARD keyword is used in the following Gloomspite Gitz warscrolls:

• Zarbag
Leader, Behemoth
15.1 Battleshock Tests
You must make a battleshock roll for each friendly unit that has to take a battleshock test. To make a battleshock roll, roll a dice and add the number of models in the unit that were slain in that turn to the roll. If the battleshock roll is greater than the unit’s Bravery characteristic, the battleshock test has been failed. If the test is failed, for each point by which the battleshock roll exceeds the unit’s Bravery characteristic, 1 model in that unit must flee. You decide which models flee. A model that flees is removed from play.

If a slain model is returned to its unit in the same turn that it is slain, it still counts as having been slain in that battle round for the purposes of battleshock tests.
14.3 Wards
Some abilities allow you to roll a dice to negate a wound or mortal wound. Abilities of this type are referred to as wards, and the dice roll is referred to as a ward roll. Unless stated otherwise, the ward roll is made before the wound is allocated to the model in question. Up to 1 ward roll can be made for each wound or mortal wound. If the ward roll is successful, the wound or mortal wound is negated and has no effect on the model.

The GOBBAPALOOZA keyword is used in the following Gloomspite Gitz warscrolls:

• Brewgit
• Spiker
© Vyacheslav Maltsev 2013-2022