Wahapedia8 site header
Blood AngelsTerrax-pattern Termite Assault Drill
8

Terrax-pattern Termite Assault Drill

NAME M WS BS S T W A Ld Sv
Terrax-pattern Termite Assault Drill * 4+ * 7 8 10 * 8 3+
A Terrax-pattern Termite Assault Drill is a single model equipped with two storm bolters, a melta cutter and a Termite drill.
DAMAGE
Some of this model’s characteristics change as it suffers damage, as shown below:
REMAINING W
M
BS
A
6-10+
8"
3+
6
3-5
6"
4+
D6
1-2
4"
5+
D3
WEAPON
RANGE
TYPE
S
AP
D
ABILITIES
14
Heavy flamer
8"
Heavy D6
5
-1
1
This weapon automatically hits its target.
0
Melta cutter
12"
Assault D3
8
-4
D6
If the target is within half range of this weapon, roll two dice when inflicting damage with it and discard the lowest result.
2
Storm bolter
24"
Rapid Fire 2
4
0
1
-
8
Twin volkite charger
15"
Heavy 4
5
0
2
-
0
Termite drill
Melee
Melee
x2
-4
3
After the bearer has made all of its attacks, roll a D6 for each model that suffered damage from this weapon this phase but has not been destroyed; on a 2+ the model being rolled for suffers a mortal wound and, if that model is not destroyed, you can roll another D6. This time, that model suffers a mortal wound on a 3+. Keep rolling a D6, increasing the result required to cause a mortal wound by 1 each time, until the model being rolled for is destroyed or the roll is failed.
WARGEAR OPTIONS
 • This model may replace both its storm bolters with either two heavy flamers or two twin volkite chargers.
ABILITIES
Subterranean Assault: During deployment, you can set up this model, along with any units embarked within it, underground instead of placing it on the battlefield. At the end of any of your Movement phases, this model can perform a subterranean assault – set it up anywhere on the battlefield that is more than 9" away from any enemy models. Any units embarked inside can then immediately disembark, but they must be set up more than 9" from any enemy models. Any models that cannot be set up because there is not enough room are slain.

Explodes: If this model is reduced to 0 wounds, roll a D6 before removing it from the battlefield and before any embarked models disembark; on a 6 it explodes and each unit within 6" suffers D3 mortal wounds.
TRANSPORT
This model can transport 12 BLOOD ANGELS INFANTRY models. It cannot transport JUMP PACK, TERMINATOR or PRIMARIS models.
FACTION KEYWORDS
IMPERIUM, ADEPTUS ASTARTES, BLOOD ANGELS
KEYWORDS
VEHICLE, TRANSPORT, TERMITE ASSAULT DRILL
Does not include wargear
Hit Roll
Each time a model makes an attack, roll a dice. If the roll is equal to or greater than the attacking model’s Ballistic Skill characteristic, then it scores a hit with the weapon it is using. If not, the attack fails and the attack sequence ends. A roll of 1 always fails, irrespective of any modifiers that may apply.
HEAVY

Heavy weapons are the biggest and deadliest guns on the battlefield, but require reloading, careful set-up or bracing to fire at full effect.

If a model with a Heavy weapon moved in its preceding Movement phase, you must subtract 1 from any hit rolls made when firing that weapon this turn.
Advancing
When you pick a unit to move in the Movement phase, you can declare that it will Advance. Roll a dice and add the result to the Move characteristics of all models in the unit for that Movement phase. A unit that Advances can’t shoot or charge later that turn.
ASSAULT

Assault weapons fire so rapidly or indiscriminately that they can be shot from the hip as warriors dash forwards into combat.

A model with an Assault weapon can fire it even if it Advanced earlier that turn. If it does so, you must subtract 1 from any hit rolls made when firing that weapon this turn.
RAPID FIRE

Rapid Fire weapons are versatile weapons capable of aimed single shots at long range or controlled bursts of fire at close quarters.

A model firing a Rapid Fire weapon doubles the number of attacks it makes if its target is within half the weapon’s maximum range.
Wound Roll
WOUND ROLL
ATTACK’S STRENGTH VS TARGET’S TOUGHNESSD6 ROLL REQUIRED
Is the Strength
TWICE (or more)
than the Toughness?
2+
Is the Strength
GREATER
than the Toughness?
3+
Is the Strength
EQUAL
to the Toughness?
4+
Is the Strength
LOWER
than the Toughness?
5+
Is the Strength
HALF (or less)
than the Toughness?
6+
If an attack scores a hit, you will then need to roll another dice to see if the attack successfully wounds the target. The roll required is determined by comparing the attacking weapon’s Strength characteristic with the target’s Toughness characteristic, as shown on the table to the right:

If the roll is less than the required number, the attack fails and the attack sequence ends. A roll of 1 always fails, irrespective of any modifiers that may apply.
Invulnerable Saves
Some models possess supernatural reflexes or are protected by force fields that grant them an invulnerable save. Each time a wound is allocated to a model with an invulnerable save, you can choose to use either its normal Save characteristic or its invulnerable save, but not both. If a model has more than one invulnerable save, it can only use one of them – choose which it will use. If you use a model’s invulnerable save, it is never modified by a weapon’s Armour Penetration value.
Mortal Wounds
Some attacks inflict mortal wounds – these are so powerful that no armour or force field can withstand their fury. Each mortal wound inflicts one point of damage on the target unit. Do not make a wound roll or saving throw (including invulnerable saves) against a mortal wound – just allocate it as you would any other wound and inflict damage to a model in the target unit as described above. Unlike normal attacks, excess damage from attacks that inflict mortal wounds is not lost. Instead keep allocating damage to another model in the target unit until either all the damage has been allocated or the target unit is destroyed.
Melee Weapon
Each time a model makes a close combat attack, it uses a melee weapon – the weapons a model is equipped with are described on its datasheet. In addition to their other weapons, all models are assumed to be equipped with a close combat weapon, which has the following profile:

WEAPONRANGETYPESAPD
Close combat weaponMeleeMeleeUser01

If a model has more than one melee weapon, choose which it will use before rolling the dice. If a model has more than one melee weapon and can make several close combat attacks, it can split its attacks between these weapons however you wish – declare how you will divide the attacks before any dice are rolled.

The JUMP PACK keyword is used in following Blood Angels datasheets:

HQ
Elites
Fast Attack
Army List

This datasheet has Dedicated Transport Battlefield Role. Full list of Blood Angels units sharing same Battlefield Role follows:

The TRANSPORT keyword is used in following Blood Angels datasheets:

HQ
Dedicated Transport
• Rhino
Flyers
Heavy Support
© Vyacheslav Maltsev 2013-2019